Bmw egs software update5/28/2023 The process of EGS reset needs to be programmed. It is recommended to remove the EGS module and operate it separately.ģ. There is a risk of EGS resetting, please be cautious!Ģ. IMMO > Accept > BMW > Smart selection > EGS transmission system > EWS_EGS statusġ. As you can see, I set it to 13.5 volts and left it at the unit’s blink setting.Ĭonnect Autel IM608 Key Programmer with OBD, press You need a stable voltage supplier and clean electricity. ![]() So I basically have to erase the eprom and factory reset it in the section where it has its immobilizer information.Ĭare must be taken when programming this type of vehicle, especially German vehicles such as BMW or Mercedes. ![]() The car starts but you have nowhere to move. If the code doesn’t match, the car won’t disassemble. The reason is that there is a password between the CAS module, which is the immobilizer, and the gearbox. ![]() It basically won’t pull out of the park even if it does. ![]() This transmission will not let us make the car drive or reverse. This car will have a gearbox swap and a new gearbox is already installed. This is a 2015 BMW X3 with a 3.0 turbo diesel engine. Autel MaxiIM IM608 Scan Tool is able to successfully program a used Transmission Controller (EGS Reset) for 2015 BMW X3 via OBD.
0 Comments
Leave a Reply. |